I am getting 40 errors of ” No net found in footprint”. I created symbol and footprint but it shown error. On schematic editor it works fine. But, in PCB mode it don’t show any connection to the ...
PCB CUPID Latest Questions
Please guy’s check and give your comments. I am very new in PCB design.
The tutorial showing how to do the board setup, one is instructed to not include F and B fab. When one applies the changes a warning about the non inclusion affecting the footprints shows. The tutorial ignores the ...
I have my project ready to make the gerber files and noticed I did not add mounting holes. Can I do it by just going to the edge cuts layer and adding the holes or must I do ...
Hi I am using this kicad latest version in Ubuntu,As I was looking into the spice software i got to know in kicad there’s also a Simulator tool which can be used for simulations. #pcbcupid Can do a ...
Hello The footprinter wizard is used in kicad 7.0.2, and the message is shown as below. how can i solve it? Thanks Albert
hello, Subject Description : The PCB layout constraint for CSP package The CSP(like a BGA) package is shown as image_1.bmp. After schematics are translated into PCB editor, the component is shown as ...
i want to use max22190ATJ ic as a component in keycad , got the symbol and footprint on snapeda and etract the file to my custom created file in my desktop , there in the schematic window from ...
Well i have made a circuit in which I need to use an relay with 01×03 screw terminal. I have connected the relay with screw terminal in the schematic but while running PCB editor and arranging components (footprints) ...
aashir awanNewbie
Hello, I’m looking for the voltage sensor of 5V which i can use for my project but couldn’t found one. Could you please recommend one in kicad i believe its not available or i couldn’t found one? Also for ...